DC-32 (ISO32) Controller Firmware Update
Updating from version 188.8.131.52 must be done using SSH
Version 184.108.40.206 (5/2/2022)
The main branch for most users.
New features will be implemented in this branch.
Version 220.127.116.11 / 18.104.22.168 (12/26/2021)
No new features will be implemented in this branch.
Version 22.214.171.124 / 126.96.36.199 (10/31/2021)
No more updates are planned.
If you have enabled firmware and/or maintenance protection (in the firmware upload or support pages, respectively), you must to disable it to perform the upgrade.
There are two parts to the firmware:
The Application Firmware version is the left side number: X.X.X.X / x.x.x.x
The Maintenance AVR version is the right-side number: x.x.x.x / X.X.X.X
In most cases, only the firmware needs to be updated.
iso32_188.8.131.52_update.zip See warning above
Extract from the '.sysupgrade file' from the zip file
-Consider enabling SSH in the "General network settings" and back up your settings before performing the update.
Installing Application Firmware Update X.X.X.X / x.x.x.x
NOTICE! The outlets should retain their state, however, it cannot be 100% guaranteed. Outlets turned on via script will likely turn off. In mission critical environments, we recommend preparing for the worst and disconnect any equipment that must not be power cycled at this time.
1. From the Main Menu, select the "Firmware Upload" link.
If there is no Firmware Upload listed, use the Reset button to clear protection bits*.
2. In the "Firmware Upload" page, press the Choose File button and select the '.sysupgrade file', then press the Upload button.
3. The update will take about 3 minutes. The page will try to reload and likely fail. Wait for about 30 more seconds, then try again.
Firmware version 1.3.x - 1.10.x Maintenance/AVR update instructions are here.
Firmware version 1.11.x and up Maintenance update instructions are here.
Thanks for choosing DLI. We appreciate your
and we'll work hard to earn your business!